My iQTS244, iQ360X, iQ360XR, iQMS362 vacuum is not sucking dust

z. Perform the DAILY Cleaning of the saw. Ensure to clean inside the walls of the blade guard.

    i. We need to distinguish between dust collection and dust on the machine so the machine will need to be clean in           order to verity if it is a dust collection issue.

aa. For iQTS244/iQ360X/iQ360XR/iQMS362, the filter must be clean for proper suction.

    i. Spin the filter and/or check the filter for cleanliness. Replace the filter if required.

bb. For the iQTS244 and iQMS362, vacuum may be checked by turning on the saw and releasing the dust tub.

    i. If the tub stays up, there is proper suction.

    ii. If the tub does not stay up, check the filter, then the seal, and the vacuum.

cc. For the iQTS244 and IQMS362, check the gap between the sliding table louvers and the vacuum suction. It should        be no more then 1/64th of an inch.

    i. Raise the vacuum suction until it rubs against the louvers then lower it.

dd.Check the collection Pan and ensure it is not full.